HearthWise Wood and pellet heat, sized and priced with the math shown
Firewood & Pellets

Best Firewood to Burn: BTU by Species, Ranked

The best firewood to burn, ranked by heat output: a BTU-per-cord table by species, hardwood vs softwood, best wood for overnight burns, and what never to burn.

Best Firewood to Burn: BTU by Species, Ranked
The short answer The best firewood is dense, dry hardwood: oak, hickory, black locust, ash and sugar maple top the charts at 24 to 28 million BTU per cord. Softwoods like pine light fast but hold half the heat and burn out quickly. The single biggest factor is still moisture: any species must be under 20 percent to burn well.

Not all firewood heats equally. A cord of hickory holds nearly twice the energy of a cord of white pine, which changes how often you reload and how many cords a winter takes. But species is only half the story: a cord of the best oak, burned wet, loses to dry pine. This guide ranks the woods by heat, then puts moisture in its proper place.

What is the best firewood to burn?

The best firewood is dense, dry hardwood, because density is stored energy. A cord is a fixed volume, 4 by 4 by 8 feet, so a denser wood packs more mass and more heat into the same stack. The top heat producers are oak, hickory, black locust, ash, beech and sugar maple.

For most households the practical answer is seasoned oak: it carries high heat, splits and stacks well, and is widely sold across North America. The rarer top-tier woods, such as osage orange and black locust, burn even hotter but are harder to find and can be hard on a stove if burned too hot.

How much heat does each firewood species give?

Heat output is measured in millions of BTU per cord of seasoned wood. The figures below are representative values from forestry extension heat-value tables; local wood and seasoning will shift them.

Firewood speciesTypeApprox. million BTU per cordNotes
Osage orangeHardwood32 to 33Highest heat; burns very hot, sparks
Shagbark hickoryHardwood27 to 28Top-tier heat and coals
Black locustHardwood27Excellent, long burns
White oakHardwood26 to 30Dense, long seasoning needed
BeechHardwood24 to 27High heat, slow to dry
Sugar mapleHardwood24Steady, clean burn
Red oakHardwood25Common, high heat, 1 to 2 yr dry
White ashHardwood24Splits easily, dries faster
Yellow birchHardwood22Good heat, lights well
Douglas firSoftwood21Best of the softwoods
Red mapleHardwood19Moderate heat
White pineSoftwood16Fast kindling, low heat
Eastern white cedarSoftwood12 to 13Kindling, lots of sparks

Oak sits in the sweet spot of high heat and wide availability, which is why the cord of firewood guide and our calculator use red oak as the reference species.

Is hardwood or softwood better?

Hardwood is better for sustained heat, softwood for starting fires. Hardwood is denser, so it holds more energy per cord and burns longer and steadier, which suits overnight and all-day heating. Softwood is lighter and resinous, so it lights fast and burns hot but quickly.

FactorHardwoodSoftwood
Heat per cordHigh (22 to 33 million BTU)Lower (12 to 21 million BTU)
Burn timeLongShort
Seasoning time1 to 2 years6 to 12 months
Best useOvernight, main heatKindling, shoulder season
Cords per winterFewerMore

The common belief that softwood is dangerous to burn is a moisture myth. Dry softwood burns cleanly; it just gives less heat and needs more frequent reloading. Wet wood of any species is what coats a flue in creosote.

What is the best firewood for an overnight burn?

For a long overnight burn, use the densest hardwood you have, well seasoned, in large splits. Oak, hickory, black locust and sugar maple hold a fire longest because their mass takes hours to burn down. Fill the firebox, establish a clean secondary burn, then turn the air down for a slow, low burn.

Softwood is the wrong fuel for overnight heat. It burns out in a couple of hours and leaves few coals to relight from in the morning. Save it for getting the fire going or for mild spring and fall days when you want a quick, short fire.

Why does moisture matter more than species?

Moisture matters more than species because wet wood spends its heat boiling off water before it can warm your home. Green wood can be 50 percent water by weight; the EPA guidance is to burn wood below 20 percent moisture. A cord of top-grade oak at 40 percent moisture delivers less usable heat than dry pine.

Wet wood also smolders, which blackens glass, makes smoke and builds creosote. Season firewood at least 6 months for softwood and 12 months or more for dense hardwood, stacked off the ground with the top covered. The seasoning guide explains how to dry wood and prove it with a moisture meter, and firewood racks keep it off the ground and air-drying.

What firewood should you never burn?

Some materials are genuinely dangerous or useless in a wood stove and should never go in the firebox:

  • Pressure-treated, painted or stained wood: releases toxic chemicals, including arsenic compounds from older treated lumber.
  • Plywood, particleboard, MDF and pallets of unknown origin: glues and coatings give off harmful fumes.
  • Driftwood: salt releases corrosive compounds that damage the stove and flue.
  • Poison ivy, oak or sumac vines: the smoke carries the irritant oil and can cause severe reactions.
  • Green or unseasoned wood: not toxic, but wastes heat and builds creosote.
  • Large amounts of softwood scrap or cardboard: flares hot and fast, risking over-firing.

Who should consider pellets instead of cordwood?

If you cannot store and season a winter of dry wood, or you want ready-to-burn fuel with consistent heat, consider pellets. Pellets arrive dry in bags and burn in a pellet stove with automatic feeding, which removes the seasoning and splitting work that firewood demands.

The trade-off is cost per unit of heat and reliance on electricity, covered in the wood pellets guide. To compare how many cords or tons your house needs either way, run it through the size and fuel calculator.

Sources: University of Maryland Extension FS-926 firewood heat values, Utah State University Forestry Extension firewood BTU chart, EPA Burn Wise: best wood-burning practices.

Frequently asked questions

Quick answers to what readers ask us most

What is the best firewood to burn?

By heat per cord, the best firewood is dense hardwood: osage orange, hickory, black locust, white oak and beech lead at roughly 27 to 33 million BTU per cord. For most buyers, well-seasoned red or white oak is the practical best, widely available and high in heat. Any wood must be dry, under 20 percent moisture.

Is hardwood or softwood better for firewood?

Hardwood holds more heat per cord and burns longer, so it is better for sustained and overnight heat. Softwood lights faster and makes good kindling and shoulder-season fuel, but it burns out quickly and you need more of it. Both burn cleanly when dry; wet wood of any kind burns poorly.

What firewood should you never burn?

Never burn pressure-treated, painted or stained wood, plywood, particleboard, pallets of unknown origin, driftwood, or vines such as poison ivy. These release toxic or corrosive fumes. Also avoid burning green, unseasoned wood, which wastes heat and builds creosote in the flue.

What is the best firewood for an overnight burn?

Dense hardwoods with the highest BTU per cord hold a fire longest: oak, hickory, black locust and sugar maple. Load the stove with large, well-seasoned splits of these, get a secondary burn established, then reduce the air for a long, slow burn.